Description
Neck-to-body contact is where a bass either locks in or falls apart under your hands, and this plate is the piece that makes that joint disappear into the wood. It’s the real Fender part, stamped “Fender Corona, California,” built for the standard 4-bolt neck mounting setup found on most Fender basses — no Micro-Tilt cutout here, so double-check your neck heel before ordering.
Whether you’re doing a proper restoration, swapping out a plate that’s gone thin from years of gig bag friction, or just want the neck joint on your project bass to look and feel factory-correct, this drops right in. Mounting screws are included, so you’re not left hunting for the right hardware at the last minute before a session or a show.
- 4-bolt neck mounting design
- Stamped “Fender® Corona, California”
- Mounting screws included
- Fits most Fender basses using four-screw neck mounting without Micro-Tilt adjustment
Small part, big impact — the neck plate is the anchor point for every note you push into that low string. Get it right and the bass just feels tighter under your palm.
Reviews
There are no reviews yet.